Oscillating Lever The fan oscillates when the lever is in a down position
Fan head angle adjustment To reset the oscillating angle, turn off the oscillating lever, move the head of the fan to the new "start" position, and turn the oscillating lever.
Tilt adjustment screws To change the degree of up or down tilt loosen screws, set position, and tighten.
Clean the fan with a soapy cloth.
Wipe with a wet rag and dry with a duster
DO NOT use gasoline benzine thinners or other solvents Lubrication is notnecessary as the motor has been lubricated and sealed at the factory
Unscrew the Clip Clamp Find a suitable place to install the fan, for example, on the dashboard or doorpost. Be sure the fan can oscillate freely Drill two holes in the bodywork about 1/8" in diameter opposite the holes in the foot-plate Secure the footplate with the tapping screws, and insert the cushion between the plate and the bodywork. Secure the unit by tightening the screw